Архив за 24.10.2019

Can’t hear anything

Can't hear anything

Im using and RTL2838UHI (rtl-sdr dongle) and SDRSharp but can't listen anything

i do get frecuencies but i can't hear anything just withe noise

could someone help me out?

https://i.redd.it/zbsrqpwhxhu31.png

submitted by /u/Maricon_catalan
[link] [comments]

Comment on Electrosense: RTL-SDR Based Crowd Sourced Spectrum Monitoring with a DC to 6 GHz Up/Downconverter by Nice

Amazing!!! Great story, very clever on your part, must have been very few people in the world had access to what you did, and homebrew! Love it!

RTL-SDR Discussion • MilAir frequencies

I'm looking for some active MilAir frequencies (225-400 mHz) to listen to in the Great Lakes region.

73, Bruce, VE3EAR

Statistics: Posted by VE3EAR — Thu Oct 24, 2019 3:00 pm


Comment on High End Per Vices Cyan Software Defined Radio Released by Deejay

Just a small question, For the receive only 100 kHz up to 18 GHz radio and all screens and antenna up and running what would be the cost? (full system)

Comment on RTL-SDR Blog V.3. Dongles User Guide by admin

Are you reading through the quickstart guide? This is the features guide, not the setup.

See: http://www.rtl-sdr.com/QSG

KerberosSDR • Re: Raspberry Pi 4?

Not sure if you have seen this ..... Might find something useful here: viewtopic.php?f=9&t=4838&p=11883&hilit=pi4#p11883

Statistics: Posted by myke — Thu Oct 24, 2019 12:17 pm


licht к «Плагин для приема «Тетра»»

Hi! Thanks for this great plugin! I would like to play around with the detection of Tetra Clients. Is there any way to detect active tetra clients and to separate them from the signals of the base stations? Any hints, ideas or documents are highly appreciated smile

Late Night Non-Directional Beacon Hunting

Late Night Non-Directional Beacon Hunting submitted by /u/22shorts
[link] [comments]

Comment on RTL-SDR Blog V.3. Dongles User Guide by john

Am a novice at this. Have read the user guide. Instructions are vague and misleading. Computer does not recognize my RTL-SDR dongle. Keep getting message “no device selected” when turning dongle on.

Comment on Tutorial: Setting up a Low Cost QRP (FT8, JT9, WSPR etc) Monitoring Station with an RTL-SDR V3 and Raspberry Pi 3 by Ira Fuchs

Using your suggested changes to the rtl_sdr and ncat commands to monitor 6m but not able to decode anything. It may be my antenna but perhaps someone could have a look here to see if this looks about right:

https://imgur.com/a/5oOvHuY

Thank! W2IHF

Перевод
Рубрики
Архивы
Октябрь 2019
Пн Вт Ср Чт Пт Сб Вс
« Сен   Ноя »
 123456
78910111213
14151617181920
21222324252627
28293031